[oldtimer]

Hi
Hope I am doing this the right way (my first post)
Have just started slotting again after 50 years and have purchased a Ninco Digital Master kit with the pitlane add on.When using the PS option I enter the race time on the console then the number of pit stops and then press start.When the hand control vibrates if you enter the pit lane the car does not stop just goes straight thru.
My question basically is the car supposed to stop with no intervention from the driver any time the pit lane is entered thru the race?
Any advice appreciated
Thanks

 

[oldtimer]

Thanks for the info Michael
Have checked your suggestions but no change
The lane change section work ok
Thsi is a new track. I purchased the digital conversion kit at the same time as this was the cheapest way to get additional controllers and chips so I have changed the console to check it out.
Looks like it might have to go back to the makers to be checked out?
Thanks again for your interest
Regards Greg

 

[oldtimer]

Michael
Problem resolved
In the manufacture they soldered the jumper wire onto the dead strip istead of the other side of the track "ho Hum"
You helped when you mentioned the dead strip I went and put a car on it and it had power.
Thanks again
Greg