SlotForum banner

Ninco track fixing

3518 Views 9 Replies 7 Participants Last post by  Doug
A bit of help please.

We have just built a new bridge section for our club circuit (4 lane Ninco) and i'm tinking of fixing it down to the ply bridge and base board.

The reason behind this is track tends to raise at the joints just enough to lift the cars out of the slot (not all the time, but more than i would like).

I had thought of hot gun glue, but thought i would see if you had any better suggestions?

many thanks

1 - 1 of 10 Posts
A hot glue gun, whilst the price of a couple of larger tubes itself initially, is the way to go.

I have laid over 60 feet of 4 lane track using this method and the reason it is better than silicon? Time.

Hot glue sets in an instant and is as pliable as silicon.

Plus you can use hot glue on cars and any other slot project you can think of actually.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.