Last week I had a competition at my place with a friend and as usual we eventually compete with the NSR Moslers.
Usually I can beat his timing but when we raced with the Moslers he beated me and destroyed my previous record.
When he offer me to test his Moslers I took down the record half second!
We both thought we were just in our best mood.
The day after I tested it again and went down even more but I felt the motor was spinning at full revs as soon as I exit the curves without any spinning of the wheels.
Yes, the gear was loose! So I tighten it and tested the car. No way I could get near the new record! So the answer was plain, with the right friction in the gear the car could exit the curves with earlier full throttle and benefitting full torque as soon the grip between the shaft and gear was restored and that happens without wheel spinning.
I tested 1000 laps with different cars and when setting the right torque to the hex screws it works a wonder and it last for a long time!
The setting works perfectly with the Moslers with Ultragrip tyres. The cars are literally glued to the track.
I have a PWM controller but I cannot get anywhere near the benefit of this mechanical friction.
Is the above something anyone has already tested?
Is it allowed to run like this in the clubs?
Three lane track 60ft
Truspeed PWM controller
NSR Mosler AW with medium suspension springs
King 21 Evo
Air wheels NSR
Old record: 5,447s
New record: 4,986s
In conclusion, this is off course an empirical and rough system but you get fantastic results. Has anyone produced a real friction system with decent results?