SlotForum banner
1 - 1 of 10 Posts

· Nobby Berkshire
1,987 Posts
Scalex pinions have much too wide a hole for an NSR Shark motor. No glue or compound will keep it in place, I would think.

SlotIt do a 9t inline brass pinion for Scalex. That'll fit. Don't worry about axlegear wear. The mesh will be fine and it won't wear more than normal.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.