SlotForum banner
1 - 1 of 1 Posts

· Registered
Joined
·
265 Posts
Hmmm, any pix? If the mag sits in a pocket underneath, then, with the body off, the chassis can be flexed slightly so that a small, sharp flat screwdriver can be used. If its a puck in a well inside, there is usually a hole on the bottom where a small punch can be used to force it up and reachable in the well. Also, if you can grab the mag with a pliers, a twisting force can pop them off the surface. Usually it doesn't take much. I haven't damaged any of my cars with these techniques.

Take your time,
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top