[bswan72]

QUOTE I tried to only switch the power base to analog and leave in the LC pieces, but I ruined two LCs doing that.

Which power supply did you use with the NINCO analog power base? My understanding is that this is okay to do this as long as you use the N-Digital power supply with the NINCO analog power base. The NINCO analog power supply is unregulated so it puts out a higher voltage which can damage the N-Digital lane changers. Also, note that some of the lane changers connect both lanes together so you will only be able to run one car at a time unless you modify the N-Digital lane changers to isolate both lanes.

Best regards,
Brian

 

[bswan72]

QUOTE I don't know much about the Ninco wall mounted transformer - In general wall mounted transformer are quite weak. Make sure your power supply can provide at least 1A of current for each car.

The N-Digital transformer is regulated. The specs are 3 amps and 14.0 volts DC.

Best regards,
Brian

 

[bswan72]

My understanding is one O2 LC module per solenoid/flipper so two would be needed for an N-Digital X LC track section. I am sure that Maurizio will confirm.

Best regards,
Brian