SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,802 Posts
Discussion Starter · #1 ·
Hi everyone i hope there is someone who can shed a light on my enquiry, a number of years ago i bought some Parma 16D type motors which have lain dormant for many years, i have decided to strip the lot down with intentions of reusing them when i took them to pieces i found all 5 had modified motor brushes which were cut in a L shape so only half the brush was touching the com obviously this must have been a performance tweak which i have never seen, and i always thought that the motor would run better with the full brush in contact with the com, antbody know of this i will give the set up a try against a standard set to see if there is any difference, hope you scratch builders can help.
Cheers Keith.
 

·
Registered
Joined
·
1,802 Posts
Discussion Starter · #4 ·
Thanks Guys the motors in question are all before the advent of sealed cans, 300slr the brushes were as you mentioned so all 5 motors must have had advanced timing as they were of the same configuration looking at what is left of the brushes they look like they have been machined that way as they are very neat and true and comparing them with ordinary one's seem harder in composition.
I have rebuilt one using the best of the brushes, filed a set of brushes and put them in another can and have compared them to standard parma 16d & super parma 16d which i have some of , running them up the one using the best of the brushes shows a distinct higher rev than the one i cobbled together both are better than the standard set up and seem about the same as the super 16d possibly slightly better, from the same period i have quite a lot of motors and have checked a Mura GP 15 which also came from the same source and that has exactly the same set up, also all the springs are much stronger than the standard one's, as i have a large box of spares i will have to rebuild some cars to see how they perform against each other.
Keith.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top