SlotForum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
44 Posts
This is my new dNano track. 1:43 rc cars.

It's 5x3mts. Painted plywood with an elevated main straight with a small pits entrance.





I need ideas on billboards. Anyone has got plans to make them on balsa wood and cardboard?











Also as these cars don't run on slots, I need to make some side walls (as I already did on the main straight) and in between the racing lines. So I want to make the guardrails that may hold the cars from passing on the the next side and bump head on into some other car. Ideas?





The track is really wide to make driving several cars easier.









If any of you has any plans to build some billboards and / or guardrails, I would appreciate if you share them. Thanks!
 

·
Registered
Joined
·
20 Posts
I have a 1/43 track as well: here.

I built my billboards at 4 inches by 6 inches, printed on card stock, then glued to foam board to make the billboard. They turned out good for the scale.

Send me a private message with your email address, and I will send you the powerpoint file I created to print the billboards.

Good Luck.
 

·
Registered
Joined
·
44 Posts
Discussion Starter · #5 ·
Thanks olsixfour!! Great track there!!! have you finished it?

Sent you a private with my email. Thanks!

I have a few ideas i will try to develop and post here when I can get into them.
 

·
Registered
Joined
·
44 Posts
Discussion Starter · #7 ·
That is a really cool track and those are the billboards i'm looking for. thanks!!!! You should try racing DNanos in that beautiful track olsixfour.
 
1 - 7 of 7 Posts
Top