SlotForum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
65 Posts
Hi guys,

I have a strange problem, that I have just noticed, when i use controller No: 2 (I have 6 connected) i can initiate a trk call but the only way to restart is to press both buttons And trigger???

The lane change works ok, the track call works ok as does Brake button when setup. All the controllers are setup identically on the PBpro. This problem is only on controller output 2, I have swapped controllers with others and it only occurs on no:2 at PB.

Anyone got any ideas. BTW it is not a major problem, but if a simple fix is possible. then great....

thx regards Mal
 

·
Registered
Joined
·
65 Posts
Discussion Starter · #4 ·
Hi Greg and Riko..
Thx for the replies,

Info..

1, PBpro+SH 1.8H
2. Fault happens in ssdc and stand alone.
3. SSDC 4.6.8
4. Regardless of which controller it is only output 2. Even if only No.2 connected.

It think it is definately an internal fault but what do I know, my knowledge of electronics is NIL.


I have not tried to flash the firmware yet or reset, I will try later this evening. Thx for your time.

regards Mal
 

·
Registered
Joined
·
65 Posts
Discussion Starter · #6 ·
Hi Andy,

I reset the PB to default settings to no avail, in SSDC throttles window, all the throttles behave exactly the same, nothing strange or out of syn.

As I said b4 not a big problem, I can live with it, so don't waste your time on this little issue.

PBProSH, PitPro and SSDC are still the best things since sliced bread...Thx guys.

regards Mal

PS. not too bothered about it to warrant a re-flash of the firmware.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top