SlotForum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
142 Posts
Is it making the chassis fit that you're concerned about? If it's the type with the PCS chassis you'll need to cut it down a bit to make it fit.

Earlier ones used a MRRC chassis but I doubt you've got one of those unless it's been sitting on the shelf a long time.
 

·
Registered
Joined
·
45 Posts
Discussion Starter · #5 ·
The front chassis mountings need to be removed to allow fitment of the PCS chassis.

The PCS chassis as mentioned needs cutting down also the sides of the chassis need trimming.

The body itself looks like it needs thinning a little in places.

Other modelling forums that I'm in sometimes have step by step building guides which are useful.

It is a quality comprehensive kit.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top