SlotForum banner
1 - 1 of 1 Posts

·
Banned
Joined
·
7,745 Posts
Discussion Starter · #1 ·
Hi Guys,
When using pit lane changers it may be necessary to swap polaity in the Liven Flipper part of the Lane Brain set up page depending how you wire the solenoids.
Example on Lane 1 the 2 greem solenoid wires are for "change" ie flipper will move to allow car to change lanes. In a normal LC situation Liven Flipper will work fine because car is moving right from lane 1 to 2. However in a pit lane exit scenario the flipper will move in the opposite direction to allow car to enter into pit lane, thus the polarity will be incorrect. Simply swap polarity of LF in the LB set up page and reconfigure LB. Done.

Cheers
Rick
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top