[TanguyG1]

Hello,

I have a question, here is my circuit below. Scalextric Digital - Arc Pro

I begin !

My question is about turning the pitlane (pic 3 + 4).

If you look good, I have a difference in height between the R2 and R2 C8234.

How can I avoid this ... Indeed ... if the car slips a little too much it goes out ...

Thank you.

Tanguy

 

[mattcrackers]

Cut some cardboard to the shape you need and place underneath.

I did this on my track because of the differences in the thickness of digital and standard pieces to level the track out.

Matt

 

[talkingcars]

I have used wooden coffee stirrers, mostly costa and mcdonalds.

 

[Mr Modifier]

Digital track pieces (including the single lane pieces typically used in the pit lane) are 10mm deep. All other track pieces are 8mm deep. 2mm packing does the job (either that or sink the digital pieces 2mm into your board!)

 

[Steven.G]

I laid 2mm Proplex sheets then laid the track, marked the digital pieces, removed track and cut out the excess.

 

[TanguyG1]

Yeah ! OK...

I do...

Thank all