SlotForum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
207 Posts
I Love SirChrisGuyW’s post and how to use the standard mounting system. AND definitely use NYLOCKS!! This picture was taken prior to nylocks being added along with the stabilizer kit. I made a POOR attempt to get a Plafit chassis to run using some body mount sponge on the flat surface of a body mount along with a packer, ( it’s a 1mm rectangular spacer) used with lower brass body mounts. When mounting the body, the shell should be a nice gentle sliding fit on the body sponge. You don't want too much compression on the foam rubber mount. This can take a bit of time but is important. This will keep the center of gravity as low as possible. Also, make sure everything is locked solid with screws when mounting the body (ie no movement of the H and T plates).
Circuit component Automotive tire Electrical wiring Gas Toy

Finished product looks like this

Bag Luggage and bags Sleeve Rectangle Wood
 
1 - 1 of 1 Posts
Top