SlotForum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
563 Posts
Discussion Starter · #1 ·
Thanks again to @nimrod444 I have a beta file for the 906LH, the longtail version of the 906.

I printed it using my Ender 3.

Laptop Hood Computer Input device Personal computer


I spent about 10-15 minutes knocking down some of those retraction blobs. Then I applied two coats of Future. A day later I painted.

Wing Aerospace manufacturer Aircraft Automotive design Plastic


While not perfectly smooth it's definitely reasonable for my use....and very little sanding. I am quite pleased. I have a buck printed for the glass so that will come shortly.

Running gear etc to follow.....3DP of course.

Thanks for looking.
 

·
Registered
Joined
·
563 Posts
Discussion Starter · #8 ·
Yes, I used Future's self-leveling attributes as the filler, figuring it would be relatively thin and light and self-curing. I could probably have gotten a better finish with a couple more coats or by dipping the entire body, but I was satisfied for my own use with two coats and the primer.

And I think these will work as inserts:
Dishware Serveware Rim Circle Auto part
 
1 - 10 of 10 Posts
Top