SlotForum banner
1 - 16 of 16 Posts

·
Registered
Joined
·
207 Posts
Preferably on a 3d printer mate😜

Sorry for the joke, ok being serious if you don’t have a 3d printer right now and don’t want to wait for it to buy it, install it etc, best way would be to comission the print to someone else, there should be someone near your place that does it in a professional way without having to be too expensive , more or less it should be around 20-30 usd for printing the 🐷, of course if you want a 3d print in carbon fiber dust melted by laser , it won’t be cheap, but a resin print with medium quality and /or filament print with good quality should suffice. Good luck with that!
May be I should have said that one was delivered yesterday ! I'm just waiting for resin,Alcohol and the washing/curing machine to be delivered .
And then learn how to use it :)
 

·
Registered
Joined
·
207 Posts
Well my first print looks really good but for some reason the scale is about 1/30 , just wondering if Chappy or GDSLOT could suggest scaling settings ?
I'm using Lychee slicer.
 

·
Registered
Joined
·
207 Posts
What gear ratio did you use and motor? I’m thinking in upgrading my piggy to a Shark 25 as found the Slot it a bit slow for the size of the piggy.
Slot It 11: 32 , took me a while to get the mesh right as the original pod was made for adjustable spherical bearings and i wanted to use plain shouldered bearings.
The motor is described on Amazon as "Scalextric upgrade" from VRC hobbies 20000rpm $17 for 3 !
It runs nicely but i haven't timed it against my other cars yet , it does have a bit of snap oversteer probally due to moving the guide back.
Thanks again to chappyman66
 
1 - 16 of 16 Posts
Top