SlotForum banner
201 - 206 of 206 Posts

· Kevs Racing Bits
6,454 Posts
Right frame of mind, yes a good way of putting it.

The chassis is 3D printed and fit to the body, it should go well if the Fly 908/3 I did a chassis for is anything to go by, in fact it's become a firm favourite car to thrash round our track.

· Registered
18,149 Posts
White Pig dismantled for the purpose of removing both mags, and fitting of new Wasp 'urethanes. All tickety-boo until the 'urethanes had to be adjusted on a rim. This resulted in the tyre tearing and rendering itself as useless. Back to sq rt one, therefore.

The joys of bu**ering about with slot cars, eh? It's actually just a very good example of things, occasionally, not going to plan. Ne'er mind. Start again.
Tire Car Automotive tire Vehicle Toy
Gadget Cable Toy Electric blue Bumper
Hood Automotive tire Tire Motor vehicle Camera lens
Vehicle Aircraft Toy Hood Car
201 - 206 of 206 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.