SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
38 Posts
#2 is the better track.

I am working on my own routed track an I have put the plastic sections in. was not hard and works well.

the problem with adding the digital bits to the wood instead of just using the plastic track is that the lane changes are sharp and you kinda need the magnets on those sections. also the magnets assure the sensor is read.

I marked out the area for the xlcs and routed a pocket out. I used 12mm MDF so I went 9? mm deep and there are no gaps and the surfaces are level.

I had to remove the tabs and connector pins from the xlcs.
 
1 - 2 of 2 Posts
Top