SlotForum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,094 Posts
The scaly power boards are a wierd set up in that it converts the AC power from your wall wart into a really crappy DC. Have you mounted all the other power boards in the "same direction"? What I mean is lets take the simple case that you mount two power track pieces one after the other. You can do this in two ways. Both the power track pieces have the "power" plugs to the outside and they are side by side. Or you can mount one so that it has the power plug to the outside and the other to the inside. I suspect that doing this will confuse the ****e out of the rectifier circuit inside the power board.

So make sure you connect them up the same way. Either both pointing out or both pointing in. This should fix the problem but its not guarenteed 100%. The alternative is to ditch the extra power boards and just run one.

cheers
rick1776
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top