Joined
·
201 Posts
I have a C7030 PB Pro with simple H power board and 22A power supply.
When I turn on the lane changers click and I get an 8A overload. Normally when I reset all is fine and I can carry on.
Just recently however, I purchased another straight lane changer and now it takes more than one press of the reset button to reset itself.
Also I seem to be needing to reset during the course of a race.
This is a nuisance because it interupts the racing.
I have 5 straight lane changers, 5 curved lane changers amd a pit lane on approx 80m of track.
All the lane changers are powered by the track.
Am I overloading the system?
Should I:
1) Just increase the overload value?
2) power the lane changers on their own circuit from the power supply,not going through the PB?
3) Something else?
Any advice would be appreciated.
Trev
When I turn on the lane changers click and I get an 8A overload. Normally when I reset all is fine and I can carry on.
Just recently however, I purchased another straight lane changer and now it takes more than one press of the reset button to reset itself.
Also I seem to be needing to reset during the course of a race.
This is a nuisance because it interupts the racing.
I have 5 straight lane changers, 5 curved lane changers amd a pit lane on approx 80m of track.
All the lane changers are powered by the track.
Am I overloading the system?
Should I:
1) Just increase the overload value?
2) power the lane changers on their own circuit from the power supply,not going through the PB?
3) Something else?
Any advice would be appreciated.
Trev