SlotForum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
2,143 Posts
If you are really brave you could try and hook the chassis up to a low voltage power supply and then carefully apply heat via a naked flame [match or lighter] directly to the plastic spur or contrate gear while it's running, try and apply it to the back of the gear and not the teeth and don't keep it on too long for obvious reasons but you will notice that after a few seconds the gears will run much quieter [if total silence then you have gone too far!].
It does work, honest Guv!
[oneofwos]
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top