SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
312 Posts
Discussion Starter · #1 ·
Hi, This is another conversion for those without massive modeling skills. The body is the Revell Easykit Countach and the chassis is made up from copper sided circuit board and various diameter brass tubing. This car behaves every bit as well as a RTR model and with a few hours careful planning and modeling you can custom build a low cost car to your own spec.

Lambourghini Countach Conversion
 

·
Registered
Joined
·
312 Posts
Discussion Starter · #5 ·
Hi GuysIt's been about 32 C where I live and acrylic paint dries pretty quick if your lucky. Thing is to get a good even coat before it starts to go off or you get a thick coat that stays soft fot months!

I'm toying witht the idea of upgrading the wheels. I have the original inserts that came with the kit and was thinking of getting some BWA's and fitting the inserts to them.

The copper sided board was a clearance lot from the local electronics hobby store. It was Au$9.00 for a 300mm sqaure board but the smaller sizes were a bit dearer !
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top