[keysandslots]

Clean the bushings with alcohol, then insert the axle. Put some CA glue on the axle and push it through the bushings, then keep turning the axle while the CA cures. I've never heard of anyone using hot glue for this, only CA. I usually add a very little bit of oil on the axle. You want to do both at once so the bushings and axle remain true across the back of the chassis.

Oh, and before you do this, make sure the bushings are glued into the chassis if necessary. No use taking out the slack from the inside of the bushing if the outside is rolling around.

Randy

 

[keysandslots]

Snurfen, no offense taken at all. Two things came to me after I posted, one was that you probably meant hot glue the bushings to the chassis and two was that I hadn't actually answered the original question at all. I didn't have time to post anything else until now.

Randy