SlotForum banner

RMS - Scalextric

1435 Views 6 Replies 5 Participants Last post by  randybrown
Anybody know where can I try the RMS Software ? It's very expensive, and it can to be bad.
See less See more
1 - 1 of 7 Posts
Hi Randy
QUOTE (randybrown @ 15 Dec 2004, 19:19)RMS was not very robust or reliable. I purchased it and immediately wrote my own software for tracking laps.
I had similar problems with unreliable lap counting ... being of a bit curious nature
, I opened up the bottom side, and found that the small copper foil spring type contacts were badly bent, to a degree where they would only make contact, if the slot activator was fully pressed to the side.

I bent the copper foil gently with my fingers, so that even a small activation would make contact, and I've never had a lap timing problem since

See less See more
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.