SlotForum banner

Routed Track Copper Taping Tool

3595 Views 0 Replies 1 Participant Last post by  MrFlippant
This taping tool is constructed from Lexan, nylon, PLA, and fasteners. The 3D printed spool holds one roll of Venture brand copper tape (not included) and the Lexan holding plate holds the tape and spool in place on the Lexan upright using the included machine screw and wing nut. The Lexan baseplate provides a solid base to slide along the routed surface while two nylon guide pins ride in the slot. Also included is a pad just aft of the tape guide that helps to press down the tape as you move the taping tool along the track surface. A tip sheet is included to get the most from your taping tool.

$40 +shipping USD

Shipping is at actual cost. Contact me with your full address for a quote including shipping.


See less See more
  • Like
Reactions: 2
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.