SlotForum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter · #1 ·
Can anyone tell me where to source these?



Its a RX to FF adapter. I thought Pink Kar made them but can't seem to find them.

Mac
 

·
Jim Moyes
Joined
·
5,043 Posts
They were Reprotec, not Pink Kar.

I've got a few of their cars with that set up.
 

·
Registered
Joined
·
123 Posts
It's actually not sold as separate part bay Reprotec.

I hope they'll sell it soon as that adaptor interests a lot of people.
 

·
Premium Member
Joined
·
572 Posts
I'm sure it wouldn't be too hard to make copies of these in resin maybe?? A bit of pocket money there for someone if they went ahead and did that. These are great for converting Scalextric that have old/knackered motors and need to be upgraded.
Cheers,
Tom.
 

·
Premium Member
Joined
·
469 Posts
These Teamslot adapters should let you adapt just about any of the standard FC/FK130 or RX motors to the old open frame chassis.

http://www.teamslot.com/tienda/product_inf...3212ba4d75a21ed

http://www.teamslot.com/tienda/product_inf...products_id=330

http://www.teamslot.com/tienda/product_inf...products_id=315

http://www.teamslot.com/tienda/product_inf...products_id=346

checkout this page to see all spares:

http://www.teamslot.com/catalogos/RECAMBIOS.jpg

You could also use a new version of the RX open frame motor from Teamslot (TS1) or Pink Kar support RV012 which includes the small HO type motor(these are pretty hard to find)

Hope this helps.
Jimmy
 

·
Nobby Berkshire
Joined
·
2,015 Posts
FF slimline motors have only been on the market for two or three years, so why would Pink Kar and reprotec have made adaptors for them years before they were around?

If they fit in an RX SCX chassis lengthways but you just need to extend the connection then simple lengths of styrene or aluminium tubing will do the trick. A pad along the bottom of the cockpit will hold the motor to stop it spinning.
 

·
Registered
Joined
·
686 Posts
QUOTE (Screwneck @ 26 Jan 2012, 12:21) <{POST_SNAPBACK}>FF slimline motors have only been on the market for two or three years, so why would Pink Kar and reprotec have made adaptors for them years before they were around?

If they fit in an RX SCX chassis lengthways but you just need to extend the connection then simple lengths of styrene or aluminium tubing will do the trick. A pad along the bottom of the cockpit will hold the motor to stop it spinning.

I can remember buying a Reprotech H-16 BRM Copy about 8 years ago with a FF slimline 050 can in it, with the adaptor. I think your timing may be a little off.

Chris
 

·
Phil Kalbfell
Joined
·
3,373 Posts
I was using these motors in slot cars about 14 years ago, I would get them out of Sony CD players, they were ideal in 60's F1 cars!
 

·
Registered
Joined
·
38 Posts
Try slotmania in Barca. I was there a year ago and bouhght a reprotec mercedes with the same adapter. They had a lot of small pieces from reprotec so Im sure they can help you but beware you may have to translate your mail into a latin tongue.

http://www.gruposlotmania.net/
 
1 - 12 of 12 Posts
Top