SlotForum banner
Cancel

sanding or cutting Ninco track

2098 Views 6 Replies 5 Participants Last post by  beardy56, 
beardy56
Hi,
Has anyone tried sanding or cutting Ninco track?
The reason I'm asking is that I have my track set up as a single lane rally with loops and ice track section but have a problem with the ridge moulded around the edge.
I would like to remove the ridge from the outer edge of the track so my cars can slide out on to the border I have both inside and outside the ice track. I have the ice track set up as 1/2 Sraight, R2 Curve, R1, R2,R1 then 1/2 straight. I get some great slides when going around the inside, up to 90deg with some cars but hane trouble with the outside lane.
At the moment the only one of my 4 cars that can ride the ridge in a slide is not even a rally car (Pionier Mustang). My Autoart Evo de-slots due to the shallow guide if I try to slide it over the ridge and my Mk1 Cortina has very low clearance and grounds on the ridge. The Ninco car that came with the World Rally set will not ride over the ridge.
Reply
Save
Like
1 - 1 of 7 Posts
scuderia_turini
Hello,
I have the same setup !
Like you. the "snow banks" on the white track were a pain, so i used a Stanley Knife to slice them from the outer edge. Using sharp blades, it was easy enough to whittle them away - always cut away from yourself and take great care. I actually ended up painting matt black onto a bit of the R1 bends as it was too slippy.

Kind regards, Leo
Reply
Save
Like
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
SlotForum
A forum community dedicated to slot car owners and enthusiasts. Come join the discussion about collections, racing, displays, models, track layouts, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
1:32 scale Cars Tracks & Scenery Scratch building Scalextric Digital (APB, ARC PRO) The Pit Lane
Top