SlotForum banner

Scaleauto motor

4014 Views 21 Replies 12 Participants Last post by  wideboy
Evening all,
I was at the shop today and they now have A scaleauto 35,000 rpm motor to fit most of our RTR cars. I have no idea what to put it in but the torque figure was amazing: 190gm/cm.(GRUNT/cm.) Over half again the power of my beloved V12/2b 25,000 motor! The prof. said the feedback has been very good on it, and it is a dollar less than the v12. (So I HAD to buy one.) Anyone tried them around here? I'll wager I'll be gearing down on my track.

Looking for a bigger hammer,
See less See more
1 - 1 of 22 Posts
Hyper top end power

...but poor braking without magnet

... and impossible to control mid range with magnet(s)

My Slot-It 25k, 26k and 29k motors are much more easier to control on the track and make better lap times.

If we would race only drag racinc this would be THE MOTOR.
See less See more
1 - 1 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.