SlotForum banner

Scaleauto motor

4018 Views 21 Replies 12 Participants Last post by  wideboy
Evening all,
I was at the shop today and they now have A scaleauto 35,000 rpm motor to fit most of our RTR cars. I have no idea what to put it in but the torque figure was amazing: 190gm/cm.(GRUNT/cm.) Over half again the power of my beloved V12/2b 25,000 motor! The prof. said the feedback has been very good on it, and it is a dollar less than the v12. (So I HAD to buy one.) Anyone tried them around here? I'll wager I'll be gearing down on my track.


Looking for a bigger hammer,
cheers!
See less See more
21 - 22 of 22 Posts
2
Evening all,
I finally put the sc07 in a car (old#6 GT40) that has been a fine test bed. First impression? WOW. A driveable Rocket! Same magnets, a bit more tire, and voila! The car was a 4.5-4.6 sec. flyer but now it has pulled down to 4.375! (over 280mph) HOOOOOHAAAAA!!!!
Puts a
on this old face. I did gear it down to a ten tooth (from 11 with the v12). I don't think it's topping quite out on my track but it does appear to have a fairly wide power band. Very nice and a dollar less, to boot!

Cheers!

PS: Two tenths doesn't sound like much, but it is truly a vast improvement. The car is a couple 'o' hundredths behind my hot rod (and high-dollar) slot-it porsche, the fastest car on the circuit so far. Durability testing results will follow when it fails!
See less See more
I would put a v12 29 in all cars my porshe 956 is rapid at any track.
21 - 22 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top