SlotForum banner
1 - 2 of 2 Posts

· Administrator
Joined
·
10,855 Posts
Just to be clear- are you talking about the end of the pinion shaft being a tad too long or the diameter of the pinion shaft being too large? There were two different types of contrate that were very similar but later ones were tighter pitch between the lips. They came in with the smaller Johnson 111, the RX motors and the Johnson 222 had the larger gap.
Or Phil's gonna tell me I'm wrong again...
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top