SlotForum banner

scalextric c7042 advanced 6 car power base

7360 Views 22 Replies 8 Participants Last post by  raikkonen_webber fan

My name is Joseph from Melbourne Australia.

I have a question about power supplies.

I have a 55 metre scalextric sport track which has booster cables soldered on spread evenly and had no issues running the standard c8217 scalextric sport power base with the 2 x c993 standard transformers that you get in the sets...however instead of using the standard scalextric 60 ohm controllers i used the Parma Economy 25 ohm controllers so all was ok....

This is the question?

I have now purchased the c7042 scalextric advanced 6 car power base. I am using the scalextric digital controllers with 2 of their c 7024 15v 4 amp power supplies.....i am still running it in analogue mode with 2 analogue cars only and im finding i dont have the same amount of power as i did before.........i dont understand this as i thought i would have much more power!!

Scalextric in the UK sent me an email saying the following and i quote, "I have spoken with my colleague who explained that standard analogue transformers were not regulated so could give an output of up to 20 volts even though there are only 12 volt transformers. The new 15v transformers are regulated so will not go above 15 volts and therefore will not be as fast."

If this is true and the 2 x c7024 transformers were designed to handle 6 digital cars in digital mode how come i have less power running 2 non digital cars in analogue mode???

Any ways i think i should buy myself a variable dc power supply so i am able to adjust the power to my liking but i would be really appreciate if you can show me or forward me some material, links or any how to you tube links on how to wire it up to my 6 car power base.....i have already purchased 2 x 3.1MM x 6.5MM DC Power connectors.

Looking forward to hearing from you with your wealth of knowledge and experience 
See less See more
1 - 2 of 23 Posts
There is no display of the 63 like we did on PB-Pro. Do the three throttle presses - that will get you to 100%

But... dont think a higher voltage will make any difference, there is a regulator inside that will just work harder to reduce the voltage back down. And in the limit you will blow that up. Early versions (prototypes) got very hot around there.
No, not in the near future. If you really want raw power try a trade against a PB-ProSH and get 30 Amps and 18V on your track...
1 - 2 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.