SlotForum banner
1 - 4 of 4 Posts

· Registered
Joined
·
478 Posts
Discussion Starter · #1 ·
I am new to this forum but have also asked this question on other forums too. i was wondering if anyone could tell me the correct way to wire a Scalextric Sport jack plug and wire into a 3 pin socket to accept a Parma controller so i can use the Parma controller on my home Scalextric Sport controller


Thanks in advance,

Doug
 

· DT
Joined
·
8,027 Posts
Julian just pipped me as I was running out to the garage to check my controllers. See we are very keen here


Red wire (brake) - tip connector
Black wire (trigger) - middle connector
White wire (full power) - ground connector
 

· Registered
Joined
·
478 Posts
Discussion Starter · #4 ·
Thanks guys this is good stuff you are all soo keen to help............ Great!
What i was also wondering was can anyone tell me which wires go to which on the controller? yu know red to white or somehting like that?

Doug
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top