SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
Got my Oxigen components the other day and I was reading the manuals before I started installing everything, and I noticed the following information:

"make sure to set the jumper on the oXigen cartridge properly: if you have an SCP 1.0, leave the
jumper in place shown in the picture, else, for SCP 1.1 and greater, remove it."

I know I am probably just missing it somewhere, but how do I know what version of SCP I have? I have had the controller for a couple of years.

Kevin
 

·
Premium Member
Joined
·
4,882 Posts
If you have had it for a couple of Years it's probably 1.0. Look at the lable where the knobs are 1.0 will just say SCP-1
A 1.1 will say SCP-1 and then underneath that 1.1

Rich
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top