SlotForum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2,549 Posts
Discussion Starter · #1 ·
I'm not sure I'm posting this in the right section, but here goes.........

Can anyone tell me where I can get replacement brushes for SCX RX- motors? I had a little accident with one. While I was doing the "soldering iron oil burn-off" trick:- There was a pop and half of the brush fired itself across the room, never to be seen again. The motor's fine, it seems a shame to have to bin it for the sake of a missing brush.

TIA
 

·
Johnny Fuglestad
Joined
·
417 Posts
I use Parma brushes, slightly bigger, i file them down. much better IMO and cheap 40usd give you 50 pair.
1,1usd give you 1 pair
 

·
Registered
Joined
·
3,646 Posts
all the small brushes fit, eg hawk 6&7 proslot euromotor jonsohn111 and you can buy precut brushes from the ALLOY SHOP. and all the springs from these motors also fit. john
 
1 - 6 of 6 Posts
Top