SlotForum banner
1 - 1 of 1 Posts

· Premium Member
Joined
·
796 Posts
I bought the 7 cheap scx nascar's, for my APB digital layout. Tried them out analogue to test if they were ok, before adding SSD-chips. Compared to my scalextric nascar's they were slow !
I Soldered in the SSD chips and the cars are still slow ! Only one place in my layout where it doesnt pass throgh with full speed !

Is it because there isnt volt/amp's enough on an ssd layout for SCX motors ? ( i got two standard scalextric powersupplys )

I tried removing the magnet on one of the cars, and it didnt change much, except for a little more sliding.

Any suggestions to what I can do to make these cars go as good as my scalextric nascars ?

Best regards

Ivan K
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top