Simple-H / Lights / Slot it Controller Problems?

1163 Views 3 Replies 3 Participants Last post by Nbase, Jul 17, 2012

MartinA

Discussion Starter · Jul 7, 2012

I run a Ninco NDigital powered using a Simple-H which has run great after help from Rich G - no problems there.

Problem 1
I recently purchased a Slit it cDigital controller for Ninco digital but have had no success in getting this to work, it will tag, and will operate the lane changers, will vibrate to indicate fast lap or out of fuel but will not control the car motor speed. I have put this to one side awaiting a test on a standard powered Ninco base. But has anyony had similar problems.

Problem 2
I recently added a ninco light set to a digital car but cannot get the lights to work, tried on different cars etc but no joy, the lights work if just powered as per an analogue car but not with my base.

Does anyone have similar experience or any explinations?
Does anyone know if the two problems are related?
Or maybe I have missed something??!

Any assistance is appreceated.

Cheers Martin

Save

1 - 1 of 4 Posts

mfogg

· #2 · Jul 7, 2012

QUOTE (MartinA @ 7 Jul 2012, 11:28) <{POST_SNAPBACK}>Problem 1
Hopefully someone else will respond on this one.

QUOTE (MartinA @ 7 Jul 2012, 11:28) <{POST_SNAPBACK}>Problem 2
I recently added a ninco light set to a digital car but cannot get the lights to work, tried on different cars etc but no joy, the lights work if just powered as per an analogue car but not with my base.
I have to ask the basic questions:

Did you connect the light kit leads to the converter chip light terminals?
Did you switch the light kit leads back and forth between the converter chip light terminals to check polarity?
Did you turn the lights on at the console?

Note that the Ninco light kit has a capacitor that takes a few seconds to charge, perhaps a little longer in N-Digital.

The test with another console will be very helpful on both problems.

_michael

Save

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month