SlotForum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
I just bought the Kenwood 956. My problem is the magnet will not stay in it's little holder. I've pushed and prodded that sucker, and it keeps popping out. I'm not ready to glue it in just yet as I may go the leaded weight route.

Any suggestions?

Kenny
 

·
Registered
Joined
·
4,634 Posts
Are you trying to put it in the right way up? (the raised bits of magnet at the ends should stick down through the holes)

If it wont stay, you could tape it in place till you decide whether you like it, then glue it if you do.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top