[KevinHa]

As a recent returnee to the wonderful world of Slot Cars can I say thank you for this forum and the excellent advice I've picked up from it.

I've got a Micro Scalextric and have been trying to use the "Slotman" track designer,
but my track isn't quite right and I think I may have the wrong figures for the corners.
Can anyone help me please ?

My settings,
Outer Diameter of tightest curve: 245
Hairpin - Radius 1 - Lane Spacing 36
90 degree curve - Radius 4 - Lane Spacing 36

(Thanks for the recommendations about the Carrera Lap Timer, lovely bit of kit !

)

 

[KevinHa]

Thanks guys, with a bit of fiddling on Slotman I've got the track down to only a 54mm gap.
Not good enough for the timing option, but near enough to save a lot of time when I want a new track.
Scrabbling around on the floor is not quite as much fun at 40 as it was when I was 7 !

I might try the 2 track system option when I have more time.
So disappointed that the official Scalextric track designer doesn't support Micro

 

[KevinHa]

QUOTE (diesel @ 22 Apr 2010, 14:26) <{POST_SNAPBACK}>I have to admit to using Ultimate Racer, where I have both hairpin and obstacle working

I have tried Ultimate Racer and with the MARCHON set it's closer to working, but still not quite there !
What settings do you have for the hairpin and crossover?

Thanks for the help,
Kev

 

[KevinHa]

Thanks to you both.
I'll have another fiddle about when I have more time.

Kev.