Slot Cars Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
198 Posts
Discussion Starter · #1 ·
I am about to go through all of my controllers in order to make them as good as they
can be, for this i would like to know the resistance when the controller is on min, and max
so that i can fidle with the controller without having the powerbase and computer setup.

Does anyone have this information?

I run the old Powerbase with Simple H and Pro.
desperately hoping that some of you wizards can make the wireless controller thing work ;-)

Thanks in advance.

Peter
 

·
Prof I T
Ting Tong
Joined
·
11,085 Posts
hi
pbpro has auto calibration built in to its firmware,you can also set them manually..min throttle is 0 and max throttle is 63.

You can also set min throttle to start further up the scale to prevent false starts and stop throttle creep.
 

·
Registered
Joined
·
198 Posts
Discussion Starter · #3 ·
Thanks Adrian.

But I am blessed with some very bad controlers and wanted to
Physicaly tvist and turn the actual slider in order to have
Maximum spand between max and min, so I was looking
For how many Ohm resistand there should be...
 

·
Greg Gaub
Joined
·
14,641 Posts
I forget the actual resistor values, but I think they might actually be printed on the boards that these things are on inside the controller.
There's a really useful app for the PC, though, that will help you see how bad they are, and even offer recommendations for resistors to add:
http://www.slotforum.com/forums/index.php?showtopic=13061#
 
1 - 5 of 5 Posts
Top