SlotForum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
Hi,

I have a Scaley Digital car (pre installed chip). This week it stuttered a bit during a few laps, then went dead. Im guessing its a fried chip but is there any way of visibly telling if that is the case?
 

·
Prof I T
Ting Tong
Joined
·
11,085 Posts
hi
i would first make sure that the wires that exit the pick up braids have not broken inside the plastic sheath.

A first glance all appears fine but if you slightly snag the wires towards you and one of them feels like elastic then you have found a break in the wire,just re_solder it and will be good to go.
 

·
Living the Life!
Joined
·
11,082 Posts
any further update on your chip??

Another possibility could be your braids need replacing. When doing this, make sure the little "feet" which make contact with the braids are sitting squarely in the guide plate as these often can be mis-fitted.
 

·
Registered
Joined
·
43 Posts
Discussion Starter · #4 ·
Thanks for the tips guys. In the end it was the braids not connecting to feet properly. Panic over!

Cheers
Sands
 

·
Premium Member
Joined
·
1,294 Posts
glad that was the problem .
plus sometimes the car will loose its Id and seem dead nornally goes to Id 1 if that happens just re Id it .
regards ade
 
1 - 5 of 5 Posts
Top