This table is all wood, but is on wheels and not only flips up for storage but also flips over with another track on the other side.
![]()
Table construction - angle iron frame opinions please
Looking for any opinions on the 4 foot x 8 foot table I'm looking at building.
I have the material so cost isn't a factor.
It would be a welded frame of 1" angle iron to support the 3/4 MDF base. There will be a couple of
supports as well under the MDF. MDF would be attached using countersunk bolts.
The table has to be stored vertically when not in use so it will pivot on side supports made of 3 inch channel
welded to a supporting base of 1 inch angle iron (dashed horizontal lines in the overhead view).
There will be locking wheels attached to the bottom of the frame so I
can roll it around. When the table is in the vertical position it will be held in place by a spring-loaded pin. Same
when in the horizontal position, but the table will also have supporting legs.
Below is the rough picture. Anyway, looking for opinions. Thanks, Mark
![]()
I have the material so cost isn't a factor.
It would be a welded frame of 1" angle iron to support the 3/4 MDF base. There will be a couple of
supports as well under the MDF. MDF would be attached using countersunk bolts.
The table has to be stored vertically when not in use so it will pivot on side supports made of 3 inch channel
welded to a supporting base of 1 inch angle iron (dashed horizontal lines in the overhead view).
There will be locking wheels attached to the bottom of the frame so I
can roll it around. When the table is in the vertical position it will be held in place by a spring-loaded pin. Same
when in the horizontal position, but the table will also have supporting legs.
Below is the rough picture. Anyway, looking for opinions. Thanks, Mark
1 - 1 of 7 Posts
1 - 1 of 7 Posts
