[RichG]

Hi keith

I have just had a quick measure and with a PSU set to 13.5 Volts then there is between 8 & 10 Volts on the flipper coil. So right on the point where it will be a bit unreliable. So unfortunately looks like a lower voltage relay is going to be needed particularily for lower track voltages.

Rich

 

[RichG]

Keith I would try something like 100 ohms in series with each coil. Thing to do is wind the PSU volts down to say 9V and check the relays are still reliable and adjust slightly if necessary.

Rich

 

[RichG]

Yes that will be fine.

Rich

 

[RichG]

Hi Keith

No need for a second relay, you will be able to power the exit flipper on the CLC using the unused changeover contacts in the first relay. Just connect the black & red connections the other way round.

Rich