SlotForum banner
1 - 1 of 1 Posts

·
Phil Kalbfell
Joined
·
3,375 Posts
Duane: You could look at Mark Gussin's site but may not be much help. I use my Dremmel cut off wheel and straight bits to cut them out. Wheel arches can be cleaned up using a small drum sanding wheel. I then sand the body with 320 or finer to remove the " weave" texture being careful not to remove any detail. Finish off with 600 and then prime and check for imperfections. I use auto spot putty to fill air holes etc then sand and prime these. The primer can then be sanded with 600 before applying the colour coats.

Phil
 
1 - 1 of 1 Posts
Top