SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
91 Posts

·
Registered
Joined
·
91 Posts
Hey Rich,
I too am suspisous about the datasheet I found because these devices can only stand a few hundred mils, Not the 2 - 2.5A range you would suspect. I assume that you have mapped out where the pcb traces are going. I was thinking that they really only need a half bridge arrangement to provide forward drive and braking. Do we know what the other components labeled a8e are? Do you know if we are working with a full bridge or just a half bridge? The p03 and n02 components could just be used to provide supply level voltage to the other components (a8e, maybe fet?) gate? If you already mapped the circuit, let me know, otherwise I will give it a closer look.
best regards,
BT
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top