SlotForum banner
1 - 5 of 5 Posts

·
Living the Life!
Joined
·
11,082 Posts
Discussion Starter · #1 ·
I have some nice TVR Speed 12s that I have chipped for digital. They run well and can power slide all the way around an R2 curve without drama but they do tend to hop out of the slot a bit too often.

The obvious answer is to fit deeper guides ......... the question is - which are the best to fit??
 

·
Living the Life!
Joined
·
11,082 Posts
Discussion Starter · #3 ·
I believe that that the guides are too short as they were designed to run on classic track. I have removed the tiny button magnet and replaced it with a small neo bar magnet that is not as strong as the standard bars as used on new cars for sport track.

I haven't tried lead yet
 

·
Registered
Joined
·
2,036 Posts
If they are the original classic track guides then they will need changing

Can you swap in some of the new guides ?

Also are the front wheels touching the track and holding the car up ?
 

·
Registered
Joined
·
2,938 Posts
Greg,

Have you done everything to lower the stance like re configuring the braids SCX style and shimming up the front axle? Are the front wheels as wide as the body will allow? Are the body screws loose to allow the body to roll without the chassis?

of course you can do this even if the guide is deeper!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top